Polycom DOC2238A Manual de usuario Pagina 145

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 160
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 144
MGC+ Hardware and Installation Manual
5-13
6. Disconnect the +5V and -5V power cables using a 9/16” (13 mm) M8 nut
driver.
7. Using a Phillips screwdriver, loosen the six spring-loaded screws on the
front panel of the MGC+50 that secure the Power Supply Module.
8. From the rear, carefully slide the Power Supply Module out through the
front panel and remove.
Tighten the two flat washers, the spring washer and the nut back to their +5V
and -5V screws on the faulty unit to be shipped to the manufacturer. These
items are delivered with the new power supply module.
PWR
OUT
Vista de pagina 144
1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 159 160

Comentarios a estos manuales

Sin comentarios