Polycom DOC2238A Manual de usuario Pagina 33

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 160
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 32
MGC+ Hardware and Installation Manual
2-13
ON 1 Remove the rear I/O panel and install the I/O card on
the chassis.
See “Installing the I/O Card for the ReadiManager
IAM” on page 2-15.
2 Remove the ReadiManager IAM front panel.
See “Removing the Blank Panel from the MGC+ Unit”
on page 2-14.
3 Install the ReadiManager IAM.
See “Inserting the ReadiManager IAM into the MGC+
Unit” on page 2-16.
The ReadiManager IAM automatically starts/boots
when inserted into its slot on the backplane.
Note: If you did not follow this procedure and installed the
ReadiManager IAM prior to installing the I/O card for the
ReadiManager IAM, then:
4 Turn the ReadiManager IAM OFF, by pushing the
SHUT Down button.
5 Turn the ReadiManager IAM ON, by pushing the
SHUT Down button again.
Table 2-2: MGC+ Power Setting During ReadiManager IAM Blade Installation
MGC+ Power
Setting
Do This
Vista de pagina 32
1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 159 160

Comentarios a estos manuales

Sin comentarios